Pre-Start Check List; Lighting Instructions - Signateur 1500131 Instructions D'assemblage Et D'entretien

Property damage, bodily harm, severe burns, and death could result from failure to follow these safety steps. These steps
should be performed after the grill has been assembled and prior to each use. DO NOT operate this grill until you have read
and understand ALL of the warnings and instructions in this manual.
• Ensure that the grill is properly assembled.
• Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it is evident there is excessive abrasion
or wear, or the hose is cut, it must be replaced prior to the grill being used. Replace with hose and regulator Model No. 1500111-0003,
which can be obtained by contacting contacting Customer Service Call: 1-866-305-4414 (English only) Mon-Fri 6AM to 2PM PST
or send us email at support@signateur.com.
• Leak check all gas connections, hose and propane tank. See section on "Leak Testing".
• Keep the fuel supply hose away from any heated surface(s).
• Position your grill on a non-combustible level surface in a well ventilated location, a safe distance 3.1 m/10 ft from combustible
materials, buildings and overhangs.
• Properly place the empty grease cup under the grease drain hole in the bottom of the grill to catch grease during use.
• DO NOT block ventilation areas in sides, back or cart compartment of grill.
• Keep the fuel supply hose away from any heated surface(s).
• The use of alcohol, prescription or non-prescription drugs may impair the consumer's ability to properly assemble or safely operate
the appliance.
• When cooking with oil or grease, have a type BC or ABC fire extinguisher readily available.
• In the event of an oil or grease fire, do not attempt to extinguish with water. Immediately call the fire department.
A Type BC or ABC fire extinguisher may, in some circumstances contain the fire.
• In the event of rain, snow, hail, sleet or other forms of precipitation while cooking with oil or grease, cover the cooking vessel
immediately and turn off the appliance burners and gas supply. Do not attempt to move the appliance or cooking vessel.
• Do not place empty cooking vessel on the appliance while in operation. Use caution when placing anything in cooking vessel while
the appliance is in operation.
• This appliance is not intended for and should never be used as a heater.
Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and
instructions contained in the preceding sections of this manual.
Follow the instructions exactly.
1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion
could occur if grill lid is down.
2. Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.
3. Turn on the fuel supply by slowly rotating the cylinder valve knob counter-clockwise to full open.
4. DO NOT stand with head, body, or arms over the grill when lighting.
LIGHTING THE MAIN BURNERS:
READ ALL INSTRUCTIONS BEFORE LIGHTING
1. Open lid before lighting burner.
2. Make sure all control knobs are in the "OFF" position.
3. Select the burner to be lit. Push and turn the control knob of that burner to the
High position.
4. Press the electronic igniter and hold for 3-5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait
5 minutes to allow gas to dissipate and repeat lighting procedure.
6. Repeat steps 3-5 for lighting each burner. Always use electronic igniter for
lighting each burner. If burner does not ignite using the push-button igniter, see
Match Lighting the Main Burners section.
7. To turn off, turn each control knob clockwise until it locks in the OFF position.
This does not turn off the gas flow from the cylinder.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section
of the owners manual.

PRE-START CHECK LIST:

DANGER
GAS LIGHTING INSTRUCTIONS:
WARNING
8