Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
1. System startup
Power ON/OFF
Connect the power plug to the power port on the back of the DVR. The system will automatically run a status check, and
will start after few seconds. You will see a wizard interface after the system loading.
2. Setup Wizard
Setup Wizard is a quick-set to enter the whole CMS. You can finish the NVR basic settings according to your requirements.
This setup wizard contains all the basic settings, like time setup, network setup, HDD format reminder, etc. The NVR will
achieve basic functions after the setup wizard has finished. If personalized settings are desired, please login to the main
menu and setup to complete this function.
2.1. Wizard interface
2.2. Administrator Login Interface
18
Wizard interface is shown below. We re-
commend the initial user finish the
guide step by step for the basic settings.
Place a check mark « √ » in the box in
the lower left corner and then click «
Next » to perform the basic settings.
Here we recommend you setup a
password for administrator and then
click « Next » for more settings ;
If you click « Cancel", you will enter di-
rectly into the « Main Menu »;
If you click « Prev. », the system goes
to the previous page.
Note : By default, the administrator
user name is: admin. There is no
password, but for better security, we
strongly recommend that you setup a
password here.
www.gigamedia.net
Publicité
Chapitres
Table des Matières
