DMG Honigum-Light Manuel page 13

tion. Follow the associated instructions for
use!
• In order to improve the adhesion of the pre-
impression material to metal or plastic trays,
a tray adhesive for A-silicones should be
applied (e.g. Tray Adhesive, DMG).
• The Intraoral-Tips are to be used for direct,
intrasulcular application around the prepara-
tion.
Recommended Use
Double-mix impressions
Fill the tray with Honigum-Putty, -Heavy or -Mono.
When doing so, hold the impression tray at a
slight angle beneath the mixing tip. Follow the
associated instructions for use!
Note: To avoid air bubbles, the end of the mix-
ing tip should stay immersed in the impression
material throughout the application process.
1. Syringe the preparation with Honigum-Light.
Note: The filling of the tray and syringing should
be completed at the same time, because the high-
er temperature in the mouth leads to a quicker
setting of the syringed material compared to the
tray material.
2. Position the tray in the mouth within the
working time, slowly and using very little
force, and allow the impression to form.
3. Remove the impression from the mouth
once the setting time has ended; see
"Removal" on page 14
Correction impression
Note: No more than 30 minutes are permitted
to elapse between the pre-impression and cor-
rection impression nor should alcohol be used
for cleaning during this time, otherwise it is not
possible to guarantee a firm bond between the
two impression materials.
1. Cut generous drainage channels into the pre-
impression for the wash and remove imper-
fections.
13