DMG Honigum-Light Manuel page 12

Insert cartridge
1. Push up the lever [A] at the back of the dis-
pensing gun and pull back the slide [B] com-
pletely.
2. Lift up the plastic lever [C], insert the car-
tridge and lock it using the plastic lever [C].
Note: Make sure that the notches on the car-
tridge line up with those on the dispensing gun.
Attach mixing tip
1. Remove the cartridge cap [D] or used mix-
ing tip by turning it 90° counterclockwise,
and discard it.
2. Attach a new mixing tip [E].
Note: In order to attain an optimum mixing result,
DMG recommends the use of the mixing tips
available from DMG. All mixing tips are available
as refill packs.
Note: Make sure that the notches on the mix-
ing tip line up with those on the cartridge.
3. Turn the mixing tip clockwise 90° to lock it.
12
4. Attach an Intraoral-Tip [F], if applicable.
Applying the material
▸ When using a cartridge for the first time,
squeeze out a pea-sized amount of material
and discard it.
▸ The material is mixed in the mixing tip by
pulling the trigger [G] of the dispensing gun
and it is then applied directly.
Note: After the application, leave the used mix-
ing tip on the cartridge to cap unused material!
Remove cartridge
1. Push up the lever [A] at the back of the dis-
pensing gun and pull back the slide [B] com-
pletely.
2. Lift up the plastic lever [C] and remove the
cartridge.
Instructions for use
▸ For the individual times applicable to the mate-
rials used, refer to the "Technical data" sec-