Maintenance; Warranty - SPARKY HD Professional FB 514 Notice Originale

screw in bracket (10) and remove the old brush. Place
the new brush, taking care that the edge of the wheel
guard (2) contacts the brush rib. Place the bracket (10)
back and fasten it.
AUXILIARY HANDLE
The auxiliary handle (11) is fastened to the gear case
through two screws. Always use the auxiliary handle
and hold the machine firmly with both hands. (Fig. 1)
DUST EXTRACTION
This power tool must only be used with a dust extraction
system. In addition, always wear approved dust mask.
Always make sure the vacuum cleaner that you use is
designed for extraction of masonry dust. Connect the
vacuum cleaner to the dust extraction port on the wheel
guard.
We recommend using industrial vacuum cleaner with
minimum technical parameters: airflow 60 l/s and cre-
ated sub-pressure (vacuum) 180 mbar.
ACCESSORIES TO BE USED WITH THIS
POWER TOOL
Diamond cup wheel Ø125 x Ø22.23 x 22 mm
WARNING! These accessories or attachments are rec-
ommended for use with your SPARKY tool specified in
this manual. The use of any other accessories or attach-
ments might present a risk of injury to persons. Only use
accessory or attachment for its stated purpose. If you
need any assistance for more details regarding these
accessories, ask your local SPARKY service centre.

Maintenance

WARNING: Always ensure that the tool is
switched off and unplugged before attempting to per-
form inspection or maintenance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop brushes.
When the carbon brushes are worn out, the machine
switches itself off. In this case both brushes must be re-
placed simultaneously with genuine brushes at SPARKY
service centre for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be loose,
retighten it immediately to avoid hazards.
In case the screws (13) loosen they have to be tightened
firmly. Prior to tightening you must lay thread locking ad-
hesive over each screw thread.
Re-lubricate all moving parts at regular intervals.
If the replacement of the supply cord is necessary, this
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
Original instructions
CLEANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the switch-
es. Use a soft brush and/or air jet to remove any accu-
mulated dust. Wear safety glasses to protect your eyes
whilst cleaning.
Exterior plastic parts may be cleaned with a damp cloth
and mild detergent if necessary.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into
contact with the tool.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
certified service centres or other qualified service or-
ganisations, always using genuine replacement parts.

Warranty

The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire Original Instructions before us-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country.
7
EN