Unpacking - Haussmann MJ10250IX Guide De L'utilisateur

ELECTRICAL INFORMATION
Use a separate electrical circuit for your tools. This circuit must consist of not less
than #12 wire with a 20 A time-delayed fuse or a #14 wire with a 15 A time-delayed
fuse. Before connecting the motor to the power line, make sure the switch is in the
OFF position and the electric current is rated the same as the current stamped on
the motor nameplate. Running at a lower voltage will damage the motor.
WARNING: THIS TOOL MUST BE GROUNDED WHILE IN USE IN ORDER TO
PROTECT THE OPERATOR FROM ELECTRIC SHOCK.

UNPACKING

Refer to below illustration.
1. Carefully remove the table saw from the carton.
2. Separate the parts.
3. Lay out all parts, and check them against the parts listed below. Examine
all parts carefully.
A. Table saw parts
Table saw assembly
Right table extension Blde guard
B. Stand parts
Stand legs
leg brackets
Bolts M6 x 14
WARNING: If any part is missing or damaged, do not plug in the table saw until
you have replaced the missing or damaged parts.
To avoid injury, the styrofoam block should be removed between the motor and
the table.
If any parts are missing or damaged, please contact Customer service at
1-866-206-0888.
38
Push stick Rip fence
Nuts M6
Long top Short top
leg brackets
Spring washers 6
Mitre gauge
Bolts M6 x 45 kickback pawls
Short bottom Long bottom
leg brackets leg brackets
Flat washers 6
!
Rear table extension Left table extension
Blade wreches
Rubber feet Nuts M6
!
Hex key