Whirlpool LDR3822HQ0 Guide D'utilisation Et D'entretien page 9

INSTALLATION INSTRUCTIONS
Before installing the exhaust system, be
Wire exhaust guard
sure to remove the wire exhaust guard that
is located at the exhaust outlet.
Use duct tape to seal all joints. Do not use
screws to secure vent. Lint may catch on
screws.
Use 4 in (10.16 cm) heavy metal vent. Do
not kink or crush flexible metal vent. It must
be fully extended to allow adequate exhaust
Better Good
air to flow. Check vent after installation.
Exhaust airflow
Use the straightest path possible when
routing the exhaust vent. Use the fewest
number of elbows and turns. Allow as much
room as possible when using elbows or
making turns. Bend vent gradually to avoid
kinking. Remove excess flexible vent to
avoid sagging and kinking that may result in
reduced airflow.
Maximum length of the exhaust system
depends upon the type of vent used,
12" (30.3 cm) 4" (10.2 cm) DIAM
number of elbows, and the type of exhaust
Rear
hood. The maximum length for both heavy
exhaust
and flexible vent is shown on the next page.
3 1 / " (8 cm)
4
outlet
Exhaust outlet at rear of dryer is located as
illustrated. Detailed instructions on spacing
for side and rear clearances can be found in
the "Recessed area and closet installation"
section.
9