Kuppersbusch ITE1780-0E Notice D'utilisation page 27

Problem
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the appli-
ance is too low/too high.
Possible cause
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The FastFreeze function is
switched on.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The FastFreeze or Intensive
Cooling function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
Solution
Contact the nearest Author-
ized Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func-
tion".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or In-
tensive Cooling manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "Fast-
Freeze or Intensive Cooling
function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
27