Installation - Kuppersbusch ITE1780-0E Notice D'utilisation

Masquer les pouces Voir aussi pour ITE1780-0E:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

28
Problem
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .

INSTALLATION

WARNING! Refer to Safety
chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Cli-
Ambient temperature
mate
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Possible cause
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula-
tion in the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
Solution
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation
can only be guaranteed within
the specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer service
or to the nearest Service Centre

Publicité

Table des Matières
loading

Table des Matières