Publicité
Les langues disponibles
Les langues disponibles
Operation
Remote Control
Your remote control has been programmed at the factory to operate with your garage door
opener.
Older LiftMaster remote controls are NOT compatible, see page 45 for compatible accessories.
Programming can be done through the door control or the learn button the garage door opener. To
program additional accessories refer to the instructions provided with the accessory or visit
LiftMaster.com. If your vehicle is equipped with a Homelink
depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional
information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING
THE PUSH BUTTON DOOR CONTROL - MODEL 882LMW
1. Press the LEARN button on the door control twice. The Command LED will blink.
2. Remote Control:
Press the button on the remote control that you wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) and the Command LED will stop
blinking when the code has been programmed. Repeat the steps above for programming additional
remote controls or keyless entry devices. If programming is unsuccessful, program the remote using
the learn button.
1
LEARN button
2
®
, you may require an external adapter
Command LED
OR
?
?
?
?
PIN
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING
THE MULTI FUNCTION DOOR CONTROL - MODEL 883LMW
1. Press and hold the LIGHT button and the push button until the push button LED begins to
blink.
2. Remote Control:
Press the button on the remote control that you wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed. Repeat the steps above for programming additional remote controls or keyless entry
devices. If programming is unsuccessful, program the remote using the learn button.
1
Push Button
2
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL USING THE LEARN BUTTON
1. Press and release the LEARN Button on the garage door opener.
2. Press and hold the button on the remote control that you wish to use. Release the button
when the garage door opener lights blink or two clicks are heard.
1
40
LIGHT/LEARN Button
OR
?
?
?
?
PIN
2
LEARN
Button
LEARN LED
Publicité
