BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
for local inspector's use.
IMPORTANT
•
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Product failure due to improper installation is not
covered under the Warranty.
WARNING
— This appliance must be
properly grounded.
IMPORTANT
•
appliance shall be conducted according to the
manufacturer's instructions.
• Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
FOR YOUR SAFETY:
WARNING
— If the information
in this manual is not followed exactly, a fire,
explosion or gas leak may result, causing
property damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance!
WHAT TO DO IF YOU
SMELL GAS:
• Do not try to light any appliance. Do not touch
any electrical switch; do not use any phone in
your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
Safety Information
— Save these instructions
— Observe all governing
— Leak testing of the
WARNING
power at the main circuit breaker or fuse box
before installing.
This cooktop has been design certified by Underwriters
Laboratories. You'll find safety precautions in your
Owner's Manual. Read them carefully.
• Installation of this cooktop must conform with
local codes or, in the absence of local codes, with
the National Fuel Gas Code, ANSI Z223.1/NFPA
54–Latest Edition.
• Be sure your cooktop is installed properly by a
qualified installer or service technician.
• To eliminate reaching over surface burners,
cabinet storage above burner should be avoided.
• Do not install the unit near an outside door or
where a draft may affect its use.
IN THE COMMONWEALTH OF MASSACHUSETTS:
• This product must be installed by a licensed
plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be the T-handle type.
• A flexible gas connector, when used, must not
exceed 3 feet.
Be sure the installation of this product in a mobile
home conforms with the Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 3280. If this standard does not apply, you
must follow the standard for Manufactured Home
Installations, ANSI A225.1 and Manufactured Home
Installations, Sites and Communities, ANSI/NFPA
501A or with local codes. You can get a copy of
the Federal Standard by Writing:
Office of Mobile Home Standards
451 7th Street, S.W.
Washington, D.C. 24010
2
— Disconnect all electrical
HUD Building