Armytek WIZARD C2 WR Manuel De L'utilisateur page 3

Initial Service
TO SET/REPLACE BATTERY
1. Unscrew the tailcap.
2. Place the battery with the positive contact (+) facing the head of the
flashlight.
3. Adjust the tailcap and tighten it as far as it can go.
The flashlight is ready for operation.
HOW TO CONNECT THE MAGNETIC CHARGER
Unscrew the tailcap to 1/4 of a circle and adjust the magnetic charger
to the tailcap.
CHARGER COLOR INDICATION
Charger not plugged in:
• Green — device is in waiting mode.
Charger plugged in:
• Green blinking — evaluation of battery voltage.
• Red blinking — unscrew the tailcap to 1/4 for charging.
• Orange blinking — USB power source voltage is too low for correct
continuation of charging or bad contact between charger and battery.
Clean the tailcap and the threads of the flashlight parts, use a diffe-
rent power source.
• Red — charging with rated charging current is going on.
• Orange — USB power source voltage is too low, charging current may
be reduced.
• Green — charging is finished.
REV_00-0003
Operation
Before use: Tighten the tailcap as far as it can go.
In OFF state:
1 click: To turn on the last used mode.
Press and hold: To turn on Firefly mode of the last used light. Keeping
button pressed will start cycling through modes of the chosen light.
Release to select.
In ON state:
1 click: To turn off the flashlight.
Press and hold: To start cycling through modes of the chosen light.
Release to select.
2 clicks: To change between white and red light in any mode.
Add/Remove Strobe modes. Unscrew the tailcap to 1/4 while the
flashlight is off, press the button, tighten the tailcap while keeping the
button pressed and then unscrew it again.
MOMENTARY ACCESS
Firefly. Press and hold the button in OFF state to start cycling through
Firefly modes. Release to select. Keeping button pressed will start
cycling through Main modes.
Main. Short click from OFF state activates Main mode if it was the last
used mode.
Turbo. Double click in any mode in ON state. The second double click
brings back last used mode.
Cycling through Main modes. In ON state press and hold the button
in any mode. Main modes will start switching cyclically. In Firefly1
cycling through Main modes starts after cycling through Firefly modes.
Release to select.
Automemorizing. After switching off the last used mode is memorized
for quick access at next switching on.
Active temperature control. When the temperature of the flashlight
becomes close to +58 °С, brightness decreases to safe value, allowing
the flashlight to avoid overheating for a long period of time. In condi-
tions of good air-cooling the flashlight delivers light without stepping
down.
WIZARD C2 WR USER MANUAL ENG 3