Operation - CAPITAL SPORTS Workspace GO Swing Mode D'emploi

Note: The Treadmill will not run
if the safety clip is not on the
handlebars and the display shows
[OFF].

OPERATION

• Make sure that the safety clip is attached to the handlebars.
• Stand on the foot rails and turn the Treadmill on by pressing the Power
button on the remote control. Make sure the remote control is pointing
down at one of the sensors. The display will count down and the treadmill
will start moving.
You can also start the Treadmill
by sliding the speed control
knob on the right handlebar
forward and keep it pressed.
• Adjust the speed of the treadmill by pressing the Speed up/down
buttons on the remote control or by sliding the speed control on the right
handlebars forward or backward.
• Move the handlebars back and forth while walking to increase the
difficulty level of the workout.
• Turn off the Treadmill, slide the speed control knob on the right
handlebars forward and keep it pressed or press the Power button on the
remote control.
7
Place the magnet of the safety clip
on the left handlebar and make sure
that it is in contact with the magnet.
Attach the clip to your clothing when
using the Treadmill. If you want
the Treadmill to stop immediately,
remove the Safety Clip from the
handlebars and the Treadmill will
stop automatically. To continue
after removing the safety clip, place
the clip back on the handlebars
and press the Power button on the
remote control.
EN
27