Table des Matières
Publicité
Mat Cutter
C O M P A C T
WORK/SURFACE/ORIENTATION
The work surface where you will place your Compact MUST BE FLAT, smooth and sturdy. Any undulation
or inconsistencies in the work surface may cause the cutting board to bow which can result in curves in
your cut. The procedure detailed in the following instructions refer to the right and left side and the top and
bottom of the machine as shown. Fig 1.
A. Blade Installation
302 Bevel Cutter
1. Remove the blade knob from the front of the bevel cutter. Remove one blade
from the package of five.
NOTE: Because the blades are packed with a small amount of oil, they may stick
together. Be certain that only one blade is being inserted into the blade slot.
2. Slide the blade down the FRONT of the chrome blade holder (sharp side down)
until the bottom right corner of the blade enters the blade slot and the hole in
the blade lines up with the hole in the blade holder. Fig 2
3. Replace the blade knob and retighten.
B. Blade Installation
701 Straight Cutting Head
1. Remove the Blade Screw and the Blade Cover from the Blade Holder. Place one
#270 blade, sharp edge down, in the slot on the Blade Holder and line up the
hole in the blade with the desired depth setting. Replace the Blade Cover and
Blade Screw. Fig. 3
NOTE: Always have the three holes on the Blade Cover lined up exactly with the
three holes on the Blade Holder before replacing the Blade Screw.
Depth Settings:
The top hole is for safely storing a blade on the cutter when not in use, the middle
hole is for standard thickness matboard and the lower hole is for 3/16" foamboard.
3
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
Fig 2
Fig 3
M O D E L 3 0 1 - S
Top
Fig 1
Right
Left
Bottom
Publicité
Table des Matières
