Check Of Contents; Identification Of Machine Components - Logan Graphic Products COMPACT 301-S Mode D'emploi

Mat Cutter
C O M P A C T

CHECK OF CONTENTS

301-S Compact - 32" base board with Mat Guide, Straight and Bevel Cutting Heads, Backing Sheet and 1 five pack of Logan #270 blades.

IDENTIFICATION OF MACHINE COMPONENTS

Guide Rail
Cutting Board
Start and Stop
Indicator
Bevel Cutting Head
Start and Stop Indicator - Line which shows where to begin and end cut.
Blade Knob - Holds blade in place for cutting
Blade Holder - Blade holding device which slides allowing blade to cut into mat.
Nylon Guides - Guides which allow Bevel Cutting Head to hook onto Guide Rail.
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
Mat Guide
Blade Knob
Blade Holder
Nylon Guides
Cutting Board
Guide Rail - Used to guide cutting heads while in use.
Mat Guide- Used to set the border width of a mat and keep
the mat in position.
Cutting Board- Vinyl covered base board of machine.
Blade Cover
Straight Cutting Head
Blade Holder - Block which holds blade in place while cutting.
Has three separate depth settings.
Blade Cover - Covers blade on Blade Holder.
Blade Screw - Holds blade in place inside Blade Holder.
M O D E L 3 0 1 - S
Blade Screw
Blade Holder
2