During Operation - AERMEC FCXI 20 AS Manuel D'utilisation Et D'installation

IMPORTANT INFORMATION AND MAINTENANCE
WARNING: the fan coil is connected
to power supply and water circuit.
Operations performed by persons
without the required technical skills can
lead to personal injury to the operator
or damage to the unit and surrounding
objects.
POWER THE FAN COIL ONLY WITH
230V, SINGLE-PHASE VOLTAGE
Any other type of power supply could
permanently damage the fan coil.
DO NOT USE THE FAN COIL
IMPROPERLY
Do not use the fan coil for animal
husbandry applications (e.g. incubation).
AIR THE ROOM
Periodically air the room in which the fan
coil has been installed. This is particularly
important if the room is occupied by
many people, or if gas appliances or
sources of odours are present.
ADJUST TEMPERATURE ADEQUATELY
The room temperature should be adjusted
in order to provide maximum comfort
to the people in the room, especially if
they are elderly, children or sick people;
avoid differences over 7°C between the
outdoor temperature and the temperature
inside the room in summer.
In summer, a temperature that is too low
causes higher electrical consumption.
CORRECTLY ADJUST THE AIR JET
Air coming out from the fan coil must not
reach people directly; in fact, even if the
air is warmer than the room temperature,
it could cause a cold sensation and result
in discomfort.
DO NOT USE EXCESSIVELY HOT WATER
To clean the fan coil use soft cloths
or sponges dipped in water with a
maximum temperature of 40°C. Do not
PACKAGING
The fan coils are shipped in standard package which consists of expanded polystyrene foam and cardboard shells.
USE
Consult control panel manual for installation and use instructions.
use chemical products or solvents for any
part of the fan coil. Do not spray water
on the outer or inner surfaces of the fan
coil (this might cause short circuits).
CLEAN THE FILTER PERIODICALLY
Cleaning the filter frequently guarantees
enhanced operating efficiency.
Check whether the filter is very dirty: in
this case, clean it more often.
Clean frequently; remove the accumulated
dust with a vacuum cleaner.
Once the filter is clean, refit it on the fan
coil following the removal instructions
but in reverse order.
SUPPLEMENTARY CLEANING
The fact that the blades of examinable
shrouds can be removed (operation done
only by adequately skilled technicians)
ensures a thorough cleaning of the internal
components, which is particularly important
when installing the unit in crowded areas or
venues requiring high hygiene standards.

DURING OPERATION

Always leave the filter fitted on the fan coil
during operation (otherwise dust in the air
could soil the coil surface area).
WHAT IS NORMAL
In cooling mode, water vapour may be
present in the air delivery of the fan coil.
In the heating operation, a slight hiss might
be heard close to the fan coil. Sometimes
the fan coil might give off unpleasant
smells due to the accumulation of
substances present in the air of the room
(clean the filter more often, especially
if the room is not ventilated regularly).
While the unit is functioning, there could
be noises and creaks inside the device
due to the various thermal expansions
of the elements (plastic and metal), but
this does not indicate any malfunction
and does not damage the unit unless
the maximum input water temperature
is exceeded.
MALFUNCTIONING
In case of malfunction, cut off power
to the unit, then energise it again and
restart the device.
WARNING! Do not attempt to repair the
unit alone, this is extremely dangerous!.
If the problem occurs again, call the local
Aftersales Service immediately.
This section is reserved for the After
Sales service only. There are 2 LEDs on
the Inverter card (Alarm / Power) that
indicate the unit's operating status. The
table for the decoding of messages is
found in Chapter Installation.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull, tread on or
crush the electric power cable, or fix it
with nails or drawing pins.
A damaged power cable can cause short
circuits and injure people.
DO NOT OBSTRUCT THE AIR OUTLETS
BY PLACING OBJECTS INTO THEM
Do not put anything in the air outlet slots.
This could injure people and damage the fan.
WARNING
Avoid that the device is used by children
or incompetent persons without
appropriate supervision; also note that
the unit should not be used by children
as a game.
IFCXIUASLJ 1210 - 5383600_04
13