Cleaning - SilverCrest SHTR 2200 E3 Mode D'emploi

__NAS278227_Haartrockner_B6.book Seite 8 Mittwoch, 28. September 2016 1:23 13
17. If you like, you can use hairspray to set
the style.
18. Do not remove the curling attachment 13
from the hair dryer until it has cooled
down.
Diffuser
Use the diffuser attachment 12 to create
curls and gentle waves in the lengths and
tips, as well as for body and volume at the
roots of the hair.
1. Figure B: Place the diffuser 12 onto
the hair dryer.
2. Switch on the hair dryer.
3. Use:
- For long hair: draw diffuser 12
through to the tips, and style the hair
into gentle waves in the direction of
the roots.
- For short hair: use the diffuser 12 to
work on the hair around the roots,
generating body and volume.
4. Do not remove the diffuser 12 from the
hair dryer until it has cooled down.
8
GB

6. Cleaning

DANGER!
Pull the mains plug 5 out of the wall
socket before you clean the hair dryer.
WARNING! Risk of material damage!
Do not use any astringent or abrasive
cleaning agents.
Clean the device regularly. Particularly en-
sure that the air inlet and outlet are free of
dust, hair and fluff.
• Wipe down the casing, the protective
grid 2 over the air inlet 3, and the styl-
ing attachment 11 using a damp cloth.
• Remove the styling attachment 11 or
the diffuser 12 from the hair dryer. Hold
the hair dryer with the air outlet 10
pointing downwards. Clean the protec-
tive discs using a brush.
Cleaning the protective grid
1. Rotate the protective grid 2 a little bit
anti-clockwise and then remove it.
2. Hold the hair dryer with the air inlet
pointing downwards. Clean the inside
and the outside protective grid using a
brush.
3. Replace the protective grid 2.
Cleaning the attachments
1. Do not remove an attachment
(11, 12, 13) from the hair dryer until
it has cooled down.
2. Wipe the attachment (11, 12, 13)
with a damp cloth.
3. Allow the attachment (11, 12, 13) to
dry completely before you use it again.