Siemens BenQ HKW-720 Mode D'emploi page 8

6 Car Kit Bluetooth
Electronics box
Please make sure that the electronics
1
box is not mounted on or between
metal objects. Only then can good
radio communication be ensured.
Make sure the electronics box
securely mounted.
Ensure that the ventilation slots on the
electronics box
least 2 cm space) and the installation
does not cause interference with any
other devices.
Do not place the connector cable be-
hind the electronics box
around the electronics box
may lead to interference.
Insulate any unused cable ends with
insulating tape.
Carefully feed the cables of the
following components to the
electronics box
aging them and then connect
them to the electronics box
• Wiring loom
6
• Display ,
• External microphone
• Antenna*
Ensure the connectors are se-
curely clicked into position and
screw on the antenna port.
* Not included in standard delivery.
® SIM (en)
1
1
are not covered (at
1
or wrap it
1
as this
1
without dam-
3
,
:
,
To relieve strain, feed the cable
of the external microphone
around the clip provided (see
picture on p. iii).
Secure the electronics box
the passenger footwell (for ex-
ample) with two screws
is
diagram on page iii.
Reconnect the car battery cor-
rectly following installation.
Dismantling the display
Detach the display
display holder
the following diagram.
1
:
1
2
, see
6
from the
7
as shown in
:
in