Monitor Audio WS-10 Mode D'emploi page 10

TroubleShooting
Should you experience any technical, or set-up problems with your subwoofer please check the Trouble Shooting guide below:
My subwoofer will not turn on/ no power.
• Is the LED illuminated on the front of the unit? If not, check your mains lead is properly connected both at the subwoofer and
at the mains outlet. Also check the fuse of the mains plug (where fitted).
• Is the LED red? If so, you have power going to the unit. It could be that there is no signal, or the 12v trigger is connected
and the source not turned on (see below).
• Have you got the 12v trigger connected? If so, the subwoofer will not power up until the source is turned on.
• Is the unit receiving a signal (12v trigger not being used)? Is the Power Mode Switch in Auto or On position, and signal source
turned on? Try adjusting the volume level of the source.
If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio immediately.
No sound from subwoofer.
• Is the LED on the front red, blue or green? If it is red, then the unit hasn't actually turned on. See above suggestions. If it is
green, then your unit is powered up and turned on in analogue LFE mode. If it is solid blue, it is in wireless mode and flashing
means it is searching for a transmitter. Check further suggestions below.
• Are the signal leads connected correctly? Check these. If possible, check by replacing with a second, working set.
• Is the volume level just very low? Try turning the volume on the source up a bit more.
• Have you tried switching input's?
If it still does not output a signal, please contact your local dealer/ distributor or Monitor Audio immediately.
8 WS-10