Publicité
Les langues disponibles
Les langues disponibles
About the power source
Use the 12 V DC or 24 V AC power source
isolated from the 100 to 240 V AC.
The usable voltage range is as follows:
12 V DC: 10.8 to 13.2 V
24 V AC: 21.6 to 26.4 V
Use the UL cable (VW-1 style 1007) for 12
V DC or 24 V AC connection.
For the 24 V AC power source, connect the
ground to the U terminal.
Recommended camera cable for
each power source
12 V DC
Cable
#24
(AWG)
(0.22
mm)
Maximum
10
cable length
(33)
(m (feet))
24 V AC
Cable
#24
(AWG)
(0.22
mm)
Maximum
30
cable length
(98)
(m (feet))
Notes
• When power is supplied to both the power
input terminal and the
power from the
• For details on the connection of the
IEEE802.3af-conforming power supply
system, refer to the Manual supplied with
the power supply system.
10
GB
Assigning the IP Address to the Camera
#22
#20
#18
(0.33
(0.52
(0.83
mm)
mm)
mm)
15
25
40
(50)
(82)
(131)
#22
#20
#18
(0.33
(0.52
(0.83
mm)
mm)
mm)
50
80
130
(164)
(262)
(426)
port, the
port is used.
Assigning the IP
Address to the
Camera
To connect the camera to a network, you
need to assign a new IP address to the
camera.
Before assigning the IP address, connect the
camera to a computer or a network. To
connect to the computer, use a commercially
available network cable (cross cable). To
connect to the network, use a commercially
available network cable (straight cable).
You can assign the IP address in two ways:
• Using the setup program stored in
the supplied CD-ROM
For details on the operations, see
"Assigning the IP Address Using the Setup
Program" on page 12.
• Using the ARP (Address Resolution
Protocol) commands
Open the DOS window on the computer and
enter the specified ARP commands.
For details on the operations, see
"Assigning the IP Address to the Camera
Using ARP Commands" in the User's Guide
stored in the supplied CD-ROM.
Notes
For determining the IP address to be
assigned to the camera, consult your system
administrator.
Publicité
