Meec tools 021332 Mode D'emploi page 48

EN
TROUBLESHOOTING
Refer to the troubleshooting chart in the event of any problems. Contact the service centre if problems
cannot be resolved with the help of the troubleshooting chart.
Problem
Engine does not start,
or starts but then stops
again.
The engine starts, but
has no power.
The engine does not run
smoothly and has no
power at high speed.
The engine smokes.
48
Possible cause
Incorrect starting procedure.
Deposits on the spark plug
electrodes, or incorrect
electrode gap.
The air filter is clogged.
Carburettor fault.
The intake grille is open, but the
suction tube is not attached.
The air filter is clogged.
Carburettor fault.
Deposits on the spark plug
electrodes, or incorrect
electrode gap.
Carburettor fault.
The bag is full, or blocked.
Incorrect fuel mixture.
Carburettor fault.
Action
Follow the instructions on how to use.
Check the spark plug.
Clean or replace the filter.
Contact the service centre.
Close the grille, or fit suction tube 1.
Clean or replace the filter.
Contact the service centre.
Check the spark plug.
Contact the service centre.
Empty the bag.
Mix the fuel according to the instructions.
Contact the service centre.