Publicité
Les langues disponibles
Les langues disponibles
BLOWER FUNCTION
IMPORTANT:
Always keep a firm grip with your right hand
in the top handle when working.
Adjust the engine speed to the material to be
removed.
•
Use a low engine speed for light material
and small twigs on grass.
•
Use a medium engine speed for grass and
leaves on a hard surface.
•
Use a high engine speed for heavier
material, such as newly fallen snow or soil.
FIG. 18
WARNING!
•
Make sure that removed material does
not cause personal injury and/or
material damage.
•
Never point the air flow at people,
animals, or into the wind.
SUCTION FUNCTION
WARNING!
•
Hold the product firmly with both hands
when working. Hold the top handle with
your left hand and the bottom handle
with your right hand, with the bag on
your right side.
•
Do not fill up the bag completely full.
•
Remove any sucked up items that could
damage the bag immediately.
•
Make sure that the bag hangs freely and
that the strap does not get twisted.
•
Do not suck up wet grass or leaves, this
can block the engine.
•
Do not overfill the bag, this will reduce
the capacity of the product and can
cause the engine to overheat.
•
The suction function works best at
medium/high speed. Keep the round end
of the tube a few centimetres over the
ground when working.
•
The bag functions as a filter, in the same
way as a normal vacuum cleaner.
FIG. 19
Emptying
1.
Switch off the engine.
2.
Open the zip on the bag.
3.
Empty the bag without taking it off the tube.
MAINTENANCE
Maintain and clean the product in accordance
with these instructions for best functionality,
safety and life span.
WARNING!
•
Switch off the engine, release the spark
plug lead from the spark plug and wait
until the engine has cooled before
cleaning and/or maintenance.
NOTE:
•
Let an authorised service centre carry
out maintenance if in doubt, or if you do
not have the necessary tools.
•
Oil and fuel should be recycled in
accordance with local regulations.
Cylinder and muffler
In order to reduce the risk of fire, clean the
cooling fins on the engine at regular intervals
with compressed air and remove dust, leaves and
other debris from the area around the muffler.
Starting system
Keep the ventilation openings on the product
clean to avoid overheating. Replace the starter
cord immediately if it shows signs of wear.
Screw unions
Check that all screw joints are properly
tightened at regular intervals and that the
handles are firmly in place.
EN
45
Publicité
