SAFETY ADVICE
EN
For your safety, this appliance complies with the applicable standards and regulations (Low Voltage,
Electromagnetic compatibility, Environment Directives, ...).
1 • OPERATING CONDITIONS
• Your vacuum cleaner is an electrical appliance: it must be used under normal operating conditions.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capacities or by persons lacking experience or knowledge unless they are supervised or given
prior instructions concerning the use of the appliance by a person responsible for their safety.
Children must be supervised to ensure they do not play with the appliance.
• Never leave the appliance running without surveillance.
• Do not hold the nozzle or the end of the tube near the eyes or the ears.
• Do not suck up warm substances (embers), large sharp fragments (glass), harmful products (solvents,
scouring agents), inflammable and explosive (based on petrol, alcohol) substances.
• Never immerse the appliance into water, throw water on the device or store it outdoors.
• Do not use the appliance: if it fell and it presents visible damage marks or operation faults. In this case,
do not unscrew the appliance but send it to the nearest Approved Service Centre or contact the Rowenta
customer service department (see the contact information on the last page).
• In case you encounter problems in obtaining the attachments and the filters for this vacuum cleaner,
contact the Rowenta customer service department (see the contact information on the last page).
2 • POWER SUPPLY
• Check if the operating voltage (tension) of your vacuum cleaner corresponds to that of your electrical installation.
• Unplug the appliance by removing the socket, without pulling the cord: immediately after use, before
each attachment change, before each cleaning, maintenance or filter changing operation.
• Do not use the device if the cord is faulty.
• The cord of your vacuum cleaner must be replaced only by an Approved Service Centre because spe-
cial tools are necessary to carry out any repairing operation in order to avoid any danger.
3 • REPAIRING WORKS
The repairing works must only be performed by specialists using original spare parts. Repairing the ap-
pliance by yourself can be dangerous for the user and cancels the warranty.
DESCRIPTION
1. Motor unit
2. On-off switch
3. Tub
4. Suction opening
5. Rollers support cradle
6. Retractable carrying handle.
7. Vent
8. Power cord
9. Cord hook for the power cord
10. Holding tabs
11. Rollers
a. Stick with mechanical variable air flow rate controller*
b. Double function universal brush*
c. Corners nozzle*
d. Home furnishings nozzle*
e. Tube positioning tool*
f. Furniture brush*
g. Brush with heating/for radiators*
h. Adaptor for the suction opening*
i. Extension tubes*
* Depending on the model: equipment specific to certain models or attachments available as option.
6