Performance Test; Maintenance Frequency - Faber e-MatriX heat 800/500 RD Manuel D'installation

Installation manual e-MatriX heat 800/500 RD,ST (LL)
For replacing the glass repeat the steps in reverse
order.
Second front glass
For cleaning only it's not necessary to remove this
glass.

Remove both glass springs at the top. See
fig. 2.2a.

Place the suction cups and remove the
front glass. See fig. 2.2b.
For replacing the glass repeat the steps in reverse
order.
5.2 Front glasses e-MatriX ST
Front glass (see fig. 1.1b, provide service from this
side)

Remove the cover strip. See fig. 2.3a, 2.3b
and 2.3c.

Rotate the glass clamp clockwise.
See fig. 2.3d and 2.3e.

Place the suction cups and remove the
glass. See fig. 2.3f.
For replacing the glass repeat the steps in reverse
order.
Second front glass
For cleaning only it's not necessary to remove this
glass.

Remove the cover strip. See fig. 2.4a, 2.4b
and 2.4c

Remove both glass springs at the top. See
fig. 2.4d

Place the suction cups and remove the
glass. See fig. 2.4e.
For replacing the glass repeat the steps in reverse
order.
5.3 Side glass e-MatriX RD
For cleaning only it's not necessary to remove this
glass.

Place the suction cups and remove the
glass. See fig. 2.1.
For replacing the glass repeat the steps in reverse
order.
6 Removing fuel bed
 Please note!
- Never lift up the fuel bed without using
the supplied handles, fig. 3.0a.
- Keep the handles for future use.
30 < < < <
e-MatriX RD,ST

Remove the front glass, see chapter 5.

Cover/remove the cover strip to avoid
scratches, see "A" fig. 3.0b.

Screw the handles in the fuel bed, see fig.
3.0a.

Lift up the fuel bed carefully, disconnect
the plug and store it at a safe place, see
fig. 3.0b.
For replacing the fuel bed repeat the steps in re-
verse order.
e-MatriX RD,ST (LL)

Remove the front glass, see chapter 5.

Cover/remove the cover strip to avoid
scratches, see "A" fig. 3.1c.

First, remove the two small logs see fig.
3.1a, before turning the handles in the
fuel bed, see fig. 3.1b.

Lift up the fuel bed carefully, disconnect
the plug and store it at a safe place, see
fig. 3.1c.
For replacing the fuel bed repeat the steps in re-
verse order.
7 Placing decoration material
 Please note!

Keep decoration material away from chil-
dren, pets and persons with reduced
physical or mental capabilities.

Don't place decoration material in the
centre area, see fig. 6.0 or fig. 6.1.
The supplied artificial ash and chips can be used to
personalize your fire!
8

Performance test


"First time water fill", see user manual
chapter 4.

Check all connections for water leakage.

Check if the extractor fan is running.

Check if the heating fan is running.

Check if the remote control is functioning
at the desired distance (max. 8m)

Replace fuel bed, see chapter 6.

Replace front glass, see chapter 5.

Perform a final functional check.
9 Maintenance
9.1

Maintenance frequency


Cleaning water sump, air filter and replac-
ing transducers.