English - Johnson Pump SPXFLOW 1600 Manuel

> English
Submersible Bilge Pump 1600, 2200 and 4000, 12/24V
Submersible bilge pump for pumping bilge water in marine environment.
To be installed in the keelson.
Security
• The pump may not be used for other
liquids than water/bilge water.
• Always install the pump according to the
wiring diagram, see page 16-18.
• Always use the fuse required, see
"Design features" below.
• The wire connections must be sealed with
a marine sealant.
• Insulation or cable sheathings must be
placed above the highest bilge water level.
• Do not run dry.
Design features
Hose size:
Capacity, straight
(13.6V/27.2V):
Capacity, 0.9m head
(13.6V/27.2V):
Voltage:
Amperage:
Fuse size:
Body:
Shaft:
Shaft seal:
Wire size:
Max height:
Max dia:
Weight:
Installation
Please follow the installation instructions carefully to assure maximum efficiency in your
bilge pump operation.
1. Remove the strainer from the bottom of the pump by depressing the lock tabs on both sides of the pump.
2. Determine the desired location for the pump. Usually it is placed in the lowest point of the bilge.
3. Position the strainer so that the pump nozzle is in the proper position to connect to the discharge hose.
6
1600
1 ¹⁄ " or 1 1/4"
8
100 l/min/(1600 GPH)
98 l/min/(1550 GPH)
12/24V DC
12V – 7A
24V – 3.5A
12V – 10A
24V – 6A
Thermoplastic
SS2343
Lip seal
1.3 mm /16 GA
2
149 mm/ 5.86"
108 mm/4.25"
1.3 kg/2.9 lb
Type designation
Pumptype
1600 12V 32-1600-01
1600 24V 32-1600-02
2200 12V 32-2200-01
2200 24V 32-2200-02
4000 12V 32-4000-01
4000 24V 32-4000-02
2200
1¹⁄ " or 1 1/4"
8
130 l/min/(2060 GPH)
120 l/min/(1900 GPH)
12/24V DC
12V – 7.5A
24V – 4.5A
12V – 12A
24V – 6A
Thermoplastic
SS2343
Mechanical seal,
carbon/ceramic
1.3 mm /16 GA
2
177 mm/6.97"
108 mm/4.25"
2.25 kg/4.96 lb
Part nr
4000
1½"or 2"
252 l/min/(4000 GPH)
164 l/min/(2600 GPH)
12/24V DC
12V – 15A
24V – 7.5A
12V – 25A
24V – 15A
Thermoplastic
SS2343
Mechanical seal,
carbon/ceramic
2 mm /14 GA
2
216 mm/8.50"
121 mm/4.76"
2.45 kg/5.40 lb
Original instructions