Bosch GCM 12 SD Professional Notice Originale page 50

OBJ_BUCH-1130-002.book Page 50 Thursday, July 1, 2010 11:44 AM
50 | English
– Adjust a vertical bevel angle, retighten
clamping lever 16 and check if the desired
clamping force has been reached.
Adjusting the Clamping Force of Clamp 5
(see figure U)
The clamping force of the handle clamp 5 can be
readjusted.
Checking:
– The clamping force of the clamp must se-
curely hold the handle in any of the
4 possible positions.
Adjusting:
– Open clamp 5.
– Turn both set screws 65 in anticlockwise di-
rection with the supplied Allen key 2
(1,5 mm) to reduce the clamping force, or in-
crease the clamping force by turning in clock-
wise direction.
Always adjust both set screws to the same
height.
– Shut clamp 5 and check if the desired clamp-
ing force has been reached.
Aligning the Angle Indicator (Horizontally)
(see figure V)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 18 to the 0° detent 17.
The lever 15 must be felt to engage in the de-
tent.
Checking:
The angle indicator 66 must be in alignment
with the 0° mark of the scale 40.
Adjusting:
– Loosen the fastening screw of the angle indi-
cator with the supplied Phillips screwdriver
35 and align the angle indicator alongside the
0° mark.
– Retighten the screw again.
Aligning the Fence
– Bring the machine into the transport posi-
tion.
– Turn the saw table 18 to the 0° detent 17.
The lever 15 must be felt to engage in the de-
tent.
1 609 929 X01 | (1/7/10)
Checking: (see figure W1)
– Set an angle gauge to 90° and place it on the
saw table 18 between the fence 20 and the
saw blade 9.
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting: (see figure W2)
– Loosen the locking screws 22 on bothe sides
of the fence extensions 21.
Loosen the setting screws 67 with the sup-
plied Allen key 35 (4 mm).
– Remove the fence extensions.
– Loosen all Allen screws 68 with the supplied
socket spanner 35 (14 mm).
– Turn the fence 20 until the angle gauge is
flush over the complete length.
– Retighten the Allen screws 68.
– Retighten the fence extensions. Tighten the
setting screws 67 only to the extent, that the
fence extensions can be moved easily.
Transport (see figure X)
Before transporting the power tool, the follow-
ing steps must be carried out:
– Loosen the locking screw 31 if tightened.
Pull the tool arm completely to the front and
tighten the locking screw again.
– Bring the machine into the transport posi-
tion.
– Remove all accessories that cannot be
mounted firmly to the power tool.
If possible, place unused saw blades in an
enclosed container for transport.
– Carry the power tool by the transport han-
dles 30 and 4 or via the recessed grips 69 on
the side of the saw table.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
The power tool should always be carried by
two persons in order to avoid back injuries.
Bosch Power Tools