Declaration Of Conformity - pewag winner profimag PMA Serie Traduction Du Mode D'emploi

Magnets with defects resulting from the following shall be excluded from the warranty:
• Normal wear and tear
• Overloading
• Improper or negligent use
• Damage
• Non-compliance with the appropriate processes and procedures
• Modifications of/changes to the pewag lifting magnet
• Incompetent use of the magnet and non-compliance with the instructions outlined in the appropriate manual
• Maintenance and/or revision work that was not completed by an authorised pewag dealer
The manufacturer shall not be liable for incidental damages or damages resulting from misuse of the lifting magnet
or from violations of these warranty terms and conditions.

Declaration of conformity

in accordance with the requirements established in Annex II, part A, of the EU Machinery Directive 2006/42/EC for
components in lifting accessories:
The person authorised to compile the technical documentation in accordance with Annex VII part A:
the legal representative pro tempore; Via Isonzo 1/E; 25017 Lonato d/G (BS); Italy
This is to inform you that the product mentioned in this operating manual complies with all the essential
requirements of the EU Machinery Directive 2006/42/EC. This declaration has no legal effect if any changes to the
product are introduced without the approval from Automagnete.
Following Norms are applied and fulfilled:
• UNI EN ISO 12100-1
• UNI EN ISO 12100-2
• UNI EN 13155
This product must not be put into service until this operating manual has been read and understood
Lonato d/G, 2015-04-21 CABLESTEEL srl
Roberto Mensi, CEO
E
17