Publicité
Les langues disponibles
Les langues disponibles
Mounting Dimensions
L Left Hand (LH) shown throughout instructions. Right Hand (RH) opposite.
Center Line of
Hinge/Pivot
A
C\v"
1
Determine the degree of door opening required and find
dimensions "A" and "B" on the chart below.
A
Opening
100°
130°
Closer
180°
B
Opening
100°
130°
PA Shoe
180°
2
Measure from center line of hinge/pivot and stick
template on door. Mark drilling holes.
L See Mounting Dimensions above as needed.
Center Line of
Door
Hinge/Pivot
A
LH
Alignment Point
3
Remove template, and drill holes where marked with a
1/8" drill bit for SRT screws.
L SRT screws are used on metal doors.
Wood screws are used on wood doors.
4
Measure and determine your door's width. Using a hex
wrench, adjust the closer spring power. Use the table
below to determine number of turns required.
Turn counterclockwise for "-"; turn clockwise for "+"
L These turns are recommended, but may change due to
door weight and environmental conditions.
Door Width
Number of Turns
ADA Setting
32" - 815 mm
36" - 915 mm
42" - 1050 mm
48" - 1220 mm
9 Z\zn"
Measurement from Door Edge
7 5/8"
6 1/8"
4 1/8"
Measurement from Door Edge
9 5/8"
8 1/8"
6 1/8"
Center Line of
Frame Stop Edge
Hinge/Pivot
B
Frame
Separate Before Using
RH
Alignment Point
-12
-6
0
−
+6
+13
EDA
Center Line of
Hinge/Pivot
Frame
Door
2C\v"
View from floor
5
Install closer onto door.
L Speed regulation valve goes away from the hinge.
6
Install EDA shoe & fifth hole spacer onto frame.
L Use the fifth hole spacer only if there is a space between
the frame and the shoe.
Optional Fifth
hole spacer
1250 Series
P.A Mount - EDA Arm
© Allegion 2015
Printed in U.S.A.
71383 Rev. 01/15-a
Bottom Frame Lip Edge
Separate Before Using
7
Rotate closer shaft 45°, attach main arm with provided
fastener.
45º
8
Adjust the closer, if necessary. See page 4 for closer
adjustment instructions.
9
Screw cap onto shaft, and install cover (optional).
+
2
1C\,"
C\,"
2"
2Z\zn"
B
2C\v"
M\zn"
Frame
Z\x"
Publicité
