Publicité
Les langues disponibles
Les langues disponibles
The 30 inch (76 cm) dimension may be reduced to not less than 24 in (61 cm) when
the wall cabinets in a domestic home are protected with fireproof materials in accordan-
ce with American National Standards - National Fuel Gas Code. To eliminate the risk of
burns or fire by reaching over heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to be provided, the risk can
be reduced by installing a range hood that projects horizontally a minimum of 5 in (13
cm) beyond the edge of the cabinets. Minimum distance between the cooktop and the
rear wall is 1" ¾. Minimum distance between the front edge of the counter and the
cooktop's front edge is 2".
!
CAUTION
: Some cabinets and building materials are not designed to withstand the heat
produced by the normal safe operation of a listed appliance. Discoloration or damage, such
as delamination, may occur.
derneath cover slot on front and back side of unit. Put in place fixing screw, without
tightening, so the bracket can slide in and out. Keeping brackets slid-in, install cooktop
in counter opening. Once units is installed, clamp down cooktop by sliding out fixing
brackets and placing its external tip on counter underneath surface, then tighten screws
slightly (over tightening may cause damage to cooktop) till unit is firmly blocked.
Once cooktop is fixed in place, remove sealing gasket excess by using a cutter or a sharp
edge tool. IMPORTANT for solid surface material installation: please insert a wooden
block between the clamp and the bottom of the countertop.
Ventilation must be in accordance with local installation code. The appliance must
be installed in a well-ventilated environment to guarantee a correct combustion gas
exchange, proper air circulation and working temperature within safety limits.
The model number plate is located on the bottom case of the cooktop. A second model
number plate is applied on the front page of the instruction booklet.
LOCATING THE COOKTOP
Do not set cooktop on locations where it may be
subject to strong drafts. Any opening in the wall
behind the cooktop should be sealed. Make
sure the flow of combustion or ventilation air is
not obstructed.
FIXING THE COOKTOP TO COUNTERTOP
A kit of sealing gasket is supplied within the
cooktop package. Install the sealing gasket
around the top surface of the cut-out perime-
ter.
This sealing gasket prevents liquids from
leaking under the cooktop.
NOTE: Do not use caulk or silicon to fix cooktop
to countertop. The cooktop must be readily re-
movable for service.
COOKTOP CLAMP DOWN INFORMATION
Before unit is installed in counter opening, you
must apply supplied fixing brackets to cooktop.
Insert bracket with offset side of angle into un-
VENTILATION
MODEL NUMBER PLATE
-8-
Publicité
