Publicité
Les langues disponibles
Les langues disponibles
installation. Check for leaks! Bubbles appearing around fittings and connections
will indicate a leak. If a leak appears, turn off supply line gas shut off valve, and
retest for leaks.
CAUTION: NEVER CHECK FOR LEAKS WITH A FLAME. WHEN LEAK CHECK IS
COMPLETE, WIPE OFF ALL RESIDUE
l)
Remove shipping polystyrene from ALL cooktop burners. The polystyrene is
meant to hold the burners in place on the burners' base, and should be used for
shipping purposes only.
CHECKING THE BURNERS' INSTALLATION
Make sure that the burners and burner covers are pro-
perly positioned, that they fit into each-other securely,
and that they are perfectly horizontal (see fig. 4).
CHECKING PRESSURE OF HOUSE PIPING SYSTEM
1)
The appliance and its individual shutoff valve
must be disconnected from the gas supply pi-
ping system during any pressure testing of that
system at test pressure in excess of ½ psi.
2)
The appliance must be isolated from the gas
supply piping system by closing its individual
manual shutoff valve during any pressure te-
sting of the gas supply piping system at test
pressure equal to or less than ½ psi.
All cooktops are equipped with both Natural Gas and LP gas injectors as well as a
convertible pressure regulator. The unit model number plate states which gas it was
adjusted for at the factory. To convert the unit to either Natural gas or LP gas one should
fit the proper burner injectors, adjust the burners for low flame and adjust the pressure
regulator converter cap.
Inlet pressure to the appliance pressure regulator should be as follows for both operation
and checking of appliance pressure regulator setting:
Gas
Natural gas
LP gas
GAS CONVERSION
MANIFOLD PRESSURE
Pressure in inches
of water column
4
11
-12-
Fig. 4
Pressure in kPa
1
2.7
Publicité
