Setting The Brightness - steel Genesi Manuel D'utilisation

5.2.1.4 Interval function
When you are in the setting phase, if the interval function shown is not confirmed within some
seconds, then you get out of the setting mode for the interval function.
You can switch off the interval function by pressing the
5.2.1.5 Fan run-on
With fan run-on, the appliance switches off automatically after 10 minutes.
Press the
The fan run-on is activatable with functions 1-2-3.
5.2.1.6 Lighting
The lighting can be switched on and off independently of the ventilation system.
Press the

5.2.1.6.1 Setting the brightness

Press and hold the
5.2.1.7 Saturation signal
If the grease filters are saturated, an audible signal sounds.
Perform the following steps:
5.2.1.7.1 Resetting the saturation signal
Press the
An audible signal sounds for 3 seconds.
The appliance switches off the saturation signal automatically after 20 hours.
28
Instructions for the user
; , , ...;
Keep pressing the push button. The display will show 1;
Keep pressing the push button, the display will show the following for the speeds of the
motor 2→3→1→2 ...;
Press the push button to confirm the speed of the motor for the interval function.
button.
button.
button until the desired brightness is reached.
Three consecutive audible signals: clean the metal grease filters.
Clean the metal grease filters; see section maintenance (page 30).
Reset the saturation indicator; see instructions under.
button.
, , or button.