steel Genesi Manuel D'utilisation page 29

Instructions for the user
5.2.1.8 Set up of the remote control
The remote control is set up by the manufacturer. If the remote control is not controlling motor or
light nearby the cooker hood, please do the following.
Keep pressing the button of the remote control and then connect the cooker hood, to confirm
that the remote control has been recognized a long beep is issued. If you do not hear the acoustic
signal within 30 seconds, please repeat the steps as described.
The remote control has a battery. When the battery is exhausted you need to:
loosen the 2 screws on the rear part and remove the cover;
take the battery out and replace it with one with the same characteristics;
close the cover again and tighten the screws.
After changing the batteries, the remote control does not need to be re-programmed.
29