EINHELL TE-AV 18/15 Li C Instructions D'origine page 19

All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
6. Operation
6.1 ON/OFF switch (Fig. 1/2)
Press the ON/OFF switch (2) to switch the equip-
ment ON and OFF.
6.2 Blowing (Fig. 1/2)
Connect the suction hose (10) to the blow con-
nector (5) of the ash vacuum cleaner.
6.3 Filter cleaning system (Fig. 13)
The equipment has a fi lter cleaning system which
enables the pleated fi lter to be cleaned when the-
re is a drop in suction performance.
Important! The fi lter cleaning system works only
when the equipment is in operation.
When the suction performance drops, proceed
as follows:
1. Close the end of the hose so that no air can
be drawn in any longer.
2. Press and hold the fi lter cleaning button (12)
for approx. 4 s.
3. Repeat step 2 four or fi ve times.
6.4 Cleaning the appliance head
(Fig. 1/Item 3)
Clean the appliance regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plas-
tic parts in the appliance.
6.5 Cleaning the container (Fig. 1/Item 7)
The container can be cleaned with a damp cloth
and some soft soap or under running water, de-
pending on the amount of dirt.
6.6 Cleaning the fi lters (Fig. 7)
Clean the fi lters (11) e.g. by tapping and brushing
or by blowing out with compressed air at low
pressure.
Anl_TC-AV_18-15_Li_C_SPK13.indb 19 Anl_TC-AV_18-15_Li_C_SPK13.indb 19
GB
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend that you clean the appliance
immediately after you use it.
7.2 Servicing
At regular intervals and before each use, check
that the fi lters in the ash vacuum are securely
fi tted.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
- 19 -
04.03.2021 08:01:40 04.03.2021 08:01:40