Luminance Brands kathy ireland HOME AMHURST LED Mode D'emploi page 10

3. Ceiling Fan Assembly
3.13
While pulling up on the 4 .5" Downrod, retighten the Set
Screws in the Motor Coupler to secure the Downrod
into place (Figure 11) .
NOTE: The Set Screws must be properly installed
as described above, or fan wobble could result.
WARNING
!
It is critical that the set screws are securely tightened.
Failure to verify that the set screws are properly
installed could result in the fan falling.
3.14
Make sure the Grommet is properly installed in the
Coupler Cover, then slide the Coupler Cover on the
Downrod until it rests on the Fan Motor Housing
(Figure 12) .
(Continued)
DOWNROD
MOTOR
COUPLER
Figure 11
DOWNROD
GROMMET
COUPLER
COVER
FAN MOTOR
HOUSING
Figure 12
10
REINSTALL
SET SCREWS (2)
ETL Model No.: CF880L