Axis OfficeBasic USB Wireless G Guide De L'utilisateur page 24

Print Server Management with the Reset
Button
The reset button can be used for several operations:
Print a test page:
The DIP switch can be set on "NOR" or "DIAG" when printing a test page.
Hold down the reset button for 5 seconds. The test page will be
printed on the connected printer.
The test page displays information about the print server's IP address,
MAC address, subnet mask, default gateway and it also lists the Access
Points in the vicinity.
Perform a Factory Default:
1. Verify that the DIP switch is on "NOR".
2. Disconnect the external power supply.
3. Hold down the reset button and reconnect the external power
supply.
4. Wait 10 seconds.
5. Release the reset button, the print server will restart.
Performing a factory default will erase all settings to default and should be performed with caution! The
default settings will be reset to:
• Infrastructure mode
• SSID = <ANY> (will connect with the Access Point that has the best signal in your wireless network)
• Channel = 6
• Data transmit rate = Auto
• Transmit mode = Auto
• Authentication Type = Open System
• Encryption = None
• DHCP = Enabled
24