Publicité
Les langues disponibles
Les langues disponibles
3. The Select A Print Server screen lists all the wireless print servers
that have been found, select the print server that you want to
configure and click Next.
If no print servers are found, check the following:
•
No Access Point in your network - you are using an Ad-Hoc
network, go to Setup in Diagnostic Mode, on page 13.
•
Access Point is encrypted and/or not broadcasting the SSID -
connect to the print server in Diagnostic mode, go to Setup in
Diagnostic Mode, on page 13.
•
Print server has automatically connected to another Access Point -
have your wireless card associate with the other Access Point and
click Refresh, or change the Access Point that the print server has
connected to, go to Setup in Diagnostic Mode, on page 13.
4. In the Change Settings screen, select Yes to change the
settings e.g. IP address. Otherwise, select No to use the default
settings and go to Installing a printer, on page 18.
The default settings are:
•
Infrastructure mode
•
SSID = <ANY>
•
Data transmit rate = Auto
•
Data transmit mode = Auto
•
Channel = 6
•
Authentication Type = Open System
•
Encryption = none
•
DHCP enabled
10
Publicité
