Axis OfficeBasic USB Wireless G Guide De L'utilisateur page 16

8. On the Wireless Security screen, set the wireless security
settings to those used by the wireless card if using Ad-Hoc
mode or those used by the Access Point if using Infrastructure
mode. Click Next.
Select the Authentication Type to be used in your wireless network:
•
- Open System
- Shared Key
- WPA-PSK
- WPA2-PSK
• Enter the encryption used in your wireless network. The options will depend
on your authentication type used. Note that CCMP (Counter Mode CBC
MAC Protocol) is sometimes known as AES (Advanced Encryption Standard).
See the User's Manual for more information on the different encryption
types.
If using WEP encryption, enter the Key Format and WEP Key or if using
•
WPA or WPA2, enter the Pre-shared Key.
9. On the TCP/IP Settings screen, specify an IP address or use a
dynamic IP address for the print server, a fixed IP address is
highly recommended. Click Next.
10. Check the settings in the Save Settings screen before they are
uploaded to the print server.
If the settings in the print server do not match those in the Access Point,
communication with the print server may be lost. If this happens, reset the print
server and start over.
11. On the Select a Printer screen, click Cancel (as you will
configure the printer later).
12. Move the DIP switch to NOR to restart the print server.
16