Axis OfficeBasic USB Wireless G Guide De L'utilisateur page 13

Setup in Diagnostic Mode
This procedure works for setting up a print server when using an
Ad-Hoc network, the Access Point is encrypted or the print server
has connected to the wrong Access Point.
Before You Start:
• Ensure that the TCP/IP protocol is installed on your computer.
• Ensure that the print server's DIP switch is switched to DIAG.
• Use a computer with a wireless card as you will connect directly to
the print server to configure it.
1. On your computer, run the software utility for the wireless card
in your computer and change it to Ad-Hoc (i.e. PEER-TO-PEER)
mode, with the following settings:
• SSID = WLAN-PS
• Channel = 6
2. Click Connect (or similar) to establish communication with the
print server. Make sure a connection is established.
3. Insert the AXIS OfficeBasic USB Wireless G CD into your
CD-drive.
4. Select Setup Wizard to install the wireless print server and
configure the connected printer.
The Wizard will automatically install these components in
C:\Program Files\Axis Communications\AXIS OBW Wizard:
• AXIS OBW Wizard.exe
• AXIS OBW Network Printer Port. DLL (Wireless Print Monitor)
After installation, AXIS OBW Wizard will be available from Start |
Programs | Axis Communications.
AXIS OBW Wizard will start in the same language as your operating
system, see Technical Specifications, on page 124.
5. From the Select A Print Server screen, select the print server that
you want to configure and click Next.
13