Lanaform Medi Stim Mode D'emploi page 14

EN
FR NL
Programme
EMS 1
EMS 2
EMS 3
EMS 4
EMS 5
Details of the cycles
Program number
EMS 3
EMS 4
EMS 5
Output amplitude increases for approximately 2s, is maintained for approximately
5s, decreases for approximately 2s then stays at 0 for around 10s.
MAINTENANCE
Cleaning the device
Before cleaning, remove the batteries from
the device.
After each use, clean the device with a soft, slight-
ly damp cloth. If it is very dirty, you can use a cloth
moistened with a gentle, soapy detergent.
Make sure that the water does not seep into the
device. If this happens, do not use the device
again until it is completely dry.
14
/ 56 English
M-MediStim-001.indd 14
Applicable areas
Preparation term Working term
Phase 1 Phase 2
30Hz/250uS 45Hz/250uS
30Hz/250uS 45Hz/250uS
30Hz/250uS 45Hz/250uS
Length of
Function
time (min.)
30 Normal
30 Normal
20 Cyclical
25 Cyclical
25 Cyclical
Phase 3
80Hz/250uS
60Hz/250uS
45Hz/250uS
To clean it, do not use any chemical cleaning
agent or abrasive product.
Cleaning self-adhesive
electrodes
So that electrodes keep their stickiness for as long
as possible, clean them carefully with a damp, lint-
free cloth.
Replace the protective film on the electrodes.
Frequency of
pulses (Hz)
50
20
30-80
30-60
30-45
Stop term
Phase 4
30Hz/250uS
30Hz/250uS
30Hz/250uS
19/12/2017 14:45:35