Adjusting Sections; Fixing The Sail Feeder - Facnor ID-LS Notice De Montage

4.10- ADJUSTING SECTIONS

Tighten the backstay to put some tension onto the forestay.
Leave the feeder piece resting on the drum.
Raise all of the sections together until they touch the top terminal of the forestay. Insert a
screw into one of the lower holes of the last section.
BEWARE: DO NOT OVERTIGHTEN IT
sections slowly descend until a hole coincides with the first of the threads on the telescopic
section.
top
40 mm-139mm

4.11- FIXING THE SAIL FEEDER

Aluminium sail entry
4.11.1- Sail feeder in aluminium (screwed) : align holes in the telescopic section with holes in
the feeder. Then, screw down the feeder with the screw provided.
4.11.2- Sail feeder in stainless steel (attached) : please refer to the separate instructions -
29160050145 reference -
F a c n or - n o ti c e de m o n ta ge 2 9 1 6 0 0 4 0 0 3 0 r e v 2 0 1 9 - e n r o u l e u r s de gé n oi s s ou s p on t I D -L S
IMPORTANT :
§
Make sure that sections have descended at least
50mm before the screw slots into place. Otherwise,
proceed to the next hole, 100mm below.
§
Leave a margin of 40-139 mm between the halyard
deflector and the bottom of the forestay top terminal.
§
The ideal position of the feeder is between 600 and
800 mm above the drum shackle.
top
4.11.1
provided in the bag of the sail feeder.
. Press the screw with your thumb and let the
Stainless steel sail feeder
(see separate instructions ref 29160050145 )
4.11.2
Hook-and-loop
fastener
- 27 -