Joie Verso Manuel D'utilisation page 12

1
2
1. Installation with ISOSAFE attachment is as
2. Place the child in the child restraint and check whether the shoulder belt
guides are at proper height.
3. Installation with 3-point-belt is show as
4. Correctly assembled 3-point-belt and ISOSAFE attachment is shown as
Make sure that both ISOSAFE connectors are securely attached to their
ISOFIX attachment anchor points. The colors of the indicators on both
ISOSAFE connectors should be completely green.
Check to make sure the child restraint is securely installed by pulling on
both ISOSAFE connectors.
Shoulder belt must pass through shoulder belt guide.
Waist belt must pass through lap belt guides.
The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely.
Never use a vehicle waist-only belt across front of child.
Do not use shoulder belt loose or positioned under arm.
Do not use shoulder belt behind child's back.
Do not allow child to slide down in the child restraint in case of strangulation.
19
3
25 29
33 34
35
35
35
35
36 44
1. Press the red button to disengage the buckle.
To assemble soft goods, reverse the steps above.
20