Lexmark C510 Guide D'installation page 19

Securing the drawer to the printer
Tighten
thumbscrew
Bracket
Prepare the printer
If you have an optional drawer, secure it
to the printer.
1
Align one bracket with the hole on
the right side of the printer as
shown. Press the bracket flat
against the printer, and then
tighten the thumbscrew.
2
Starting at the front of the printer,
push the right side cover onto the
printer, fitting each slot on the
cover over its corresponding tab
on the optional drawer, to cover the
gap between the printer and the
optional drawer.
Note the side cover orientation.
The side cover is flat on the
bottom.
13