Lexmark C510 Guide D'installation page 17

Step 3: Position the optional
CAUTION:
If you are adding an optional drawer
sometime after setting up the printer, be sure to turn the
printer off, unplug the power cord, and disconnect all
cables from the back of the printer before completing
these tasks.
Note:
When you add or remove the optional drawer,
remember to update the printer configuration through your
printer driver.
drawer
Position the optional drawer
Your printer supports an optional
530-sheet drawer. The optional drawer
consists of a support unit and a tray.
1
Unpack the box. Enclosed are:
•
•
•
2
Remove all packing material and
tape from the support unit.
3
Pull the tray out of the support unit.
Remove any packing material and
tape from the tray.
4
Move the support unit to the
location selected for the printer.
5
Tip the tray slightly and push it fully
into the support unit.
11
a support unit with the tray
inside
two side covers (left and right)
two metal brackets (left and
right) with thumbscrews