Luminance Brands kathy ireland HOME GEODE Mode D'emploi page 9

3. Ceiling Fan Assembly
3.11
Place the Ceiling Cover over the 4 .5" Downrod
(Figure 11) .
Be sure that the Ceiling Cover and the Coupler Cover
are both oriented correctly (Figure 11) .
3.12
Route the Three Motor Wires through the Hanger Ball
(Figure 12) .
Reinstall the Hanger Ball on the 4 .5" Downrod as
follows:
Position the Pin through the Two Holes in the
4 .5" Downrod and align the Hanger Ball so the Pin is
captured in the Groove in the top of the Hanger Ball
(Figure 12) .
Pull the Hanger Ball up tight against the Pin and
securely retighten the Phillips Head Set Screw in the
Hanger Ball (Figure 12) .
A loose Phillips Head Set Screw could create fan
wobble .
3.13
The Fan comes with Black, Blue and White Wires that
are 80-inches long .
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball/Downrod
Assembly (Figure 13) .
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires .
Please call Customer Service at 1-800-777-4440
if you have any questions about installation and
operation of this Ceiling Fan .
(Continued)
Figure 11
PIN
HANGER BALL
4.5"
DOWNROD
Figure 12
6 TO 9
INCHES
1/2
INCH
Figure 13
9
SET SCREW
BLACK WIRE
BLUE WIRE
WHITE WIRE
HANGER
BALL
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF370