Luminance Brands kathy ireland HOME GEODE Mode D'emploi page 7

3. Ceiling Fan Assembly
3.5
Carefully turn the partially assembled Ceiling Fan right
side up and place the Fan securely into the packing
styrofoam . Careful not to bend the Blades .
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 4 .5" Downrod (Figure 5) .
Remove the Pin from the 4 .5" Downrod, then remove
the Hanger Ball (Figure 5) .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .12 .
Note: Do not loosen the Screw that attaches the
Green Ground Wire to the Hanger Ball.
3.6
Separate, untwist and unkink the Three 80" Motor
Wires .
Route the Three 80" Black, Blue, and White Motor
Wires through the 4 .5" Downrod (Figure 6) .
3.7
Loosen the Two Phillips Head Set Screws in the Motor
Coupler for installation of the 4 .5" Downrod (Figure 7) .
Seat the 4 .5" Downrod in the Motor Coupler (Figure 7) .
Rotate and align the Two Downrod Clevis Pin Holes
with the Two Motor Coupler Clevis Pin Holes (Figure 7) .
(Continued)
PIN
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 5
THREE 80" MOTOR
WIRES (UNTWISTED)
Figure 6
Figure 7
7
GREEN GROUND WIRE
4.5" DOWNROD
HANGER BALL
4.5" DOWNROD
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF370