Publicité
Les langues disponibles
Les langues disponibles
Resetting the Lamp Time
Reset the lamp time when you have replaced the lamp.
It provides an estimated timing for lamp replacement
Resetting the lamp time from the menu
screen
Press the [MENU] button to display
1
the menu
Select "Function"""Lamp Reset"
2
from the menu
.
On the "Reset Lamp Time?" screen,
3
select "Yes" and press the [OK] button
The lamp time is reset to zero.
0
Reset Lamp Time?
Yes
.
Maintaining the Cabinet and Remote Control
Gently wipe off dirt on the cabinet with a soft cloth.
0
If it is extremely dirty, wet a cloth in water, wring dry and use it to wipe off the dirt, followed by wiping again with a
0
dry cloth.
Pay attention to the following as the cabinet may deteriorate in condition or the paint may come off.
0
Do not wipe with thinner or benzine
0
Do not allow prolonged contact with rubber or plastic products
0
Do not spray volatile chemicals such as insecticide
0
Function
Trigger
Off
Off Timer
Off
ECO Mode
Off
Network
Remote Code
A
Lamp Reset
Exit
Operate
Back
MENU
Select
BACK
No
Resetting the lamp time using the remote
control
Insert the power plug into the power
1
outlet
Make sure that you operate the
remote control in the Standby mode
2
(the power plug is inserted into the
outlet, but the power is not turned on)
Press in the order as shown.
0
Make sure that you press a button within two
0
seconds after the last button is pressed.
Press the last button for at least two seconds.
.
The "LAMP" indicator and "STANDBY/ON"
0
indicator blink alternately for three seconds.
After that, the unit switches to the Standby
mode.
MEMO
Reset the lamp time only when you have replaced the
0
lamp.
If the lamp time is reset while a lamp is in use, you may
lose track of the timing for replacing the lamp. Doing
so may result in using the lamp beyond the estimated
limit, thereby causing lamp blowout.
Press for 2
seconds or longer
63
Publicité
