JVC DLA-RS67 Instructions page 59

Function
Trigger
For setting whether to supply a 12 V output to devices such as an external screen equipped with a trigger function.
Setting
Off
On (Power)
On (Anamo)
Off Timer
For setting the duration before the power turns off automatically when the projector is not operated.
Setting values: "1 Hour", "2 Hours", "3 Hours" and "4 Hours"
0
ECO Mode
For setting the "ECO Mode", which reduces power consumption when the projector is in the standby state.
Setting
On
Off
Network
Specify the settings below during external control such as from a PC or smartphone.
Setting
DHCP Client On
Off
IP Address
Subnet Mask
Default Gateway
MAC Address
Set
No output.
Outputs control signals (12 V) from the trigger terminal when the power is turned
on.
After the power is turned off, output stops when the unit shifts to the Standby
0
mode after cooling is complete.
You can also output signals in the Standby mode by pressing the [OK] button.
0
Outputs control signals when the "Anamorphic" setting is switched from "Off" to "A"
or "B".
Minimizes power consumption in the Standby mode.
If there is no signal transmission and operation for 30 minutes while an image
0
is projected, the power is turned off automatically.
Set to "Off" if RS-232C / LAN communication is performed or the HDMI link function
is used in the Standby mode.
Obtains the IP address automatically from the DHCP server inside the connected
network.
For configuring the network settings manually.
For configuring the IP address.
For configuring the subnet mask.
For configuring the default gateway.
Displays the MAC address of the unit.
Applies the network settings.
Description
Description
Description
59