Gemini 1D002554 Mode D'emploi page 9

1. ARMING:
To arm the system, press remote control BUTTON 1. Operation will be confirmed by 1 flash of the turn indicators, 2
Beeps (if enabled) and the on‐board LED will turn ON steady. From this moment on the immobilizer, if connected,
will no longer allow to start the engine.
If during the arming delay, the seat/topcase input detects an anomaly (ex. seat open), it will be signaled by 1 flash of
the turn indicators and 1 Bop after the arming confirmation tones.
2. ARMING DELAY:
After the arming confirmation tones, the LED turns ON steady to signal the arming delay countdown. Alarm events
which might occur during the 20 sec. countdown will be ignored.
3. TILT SENSOR EXCLUSION:
To switch off the sensor, press BUTTON 4 within the first 4 sec. of the arming delay countdown. The LED will quickly
turn OFF then switch back ON steady to confirm successful exclusion. Sensor operation will be restored upon re‐
arming the alarm.
4. SIREN EXCLUSION:
During the first 4 sec. of the arming delay, the siren can be excluded by pressing remote control BUTTON 2. A quick flash of
the turn indicators will confirm exclusion. The siren sound will be restored upon re‐arming the alarm.
5. SYSTEM ARMED:
The system will be fully armed after the arming delay countdown. The LED will flash to confirm the armed state.
6. ALARM EVENTS:
If an alarm event is detected during the armed state, the siren (if not previously excluded during the arming
countdown), will sound and the turn indicators will flash repeatedly (0,5" ON – 0,5" OFF) for up to 25 sec.
ALARM EVENT
Ignition attempt
Tilt sensor
Wire tampering
Seat/topcase input
Alarm cycles can be interrupted, without disarming the system, by pressing remote control BUTTON 2.
7. SYSTEM DISARMING WITHOUT ALARM MEMORY:
If no alarm event has been detected, press remote control BUTTON 1 to disarm the system. Operation will be
confirmed by 3 Beeps and 3 flashes of the turn indicators. The engine can then be started.
8. SYSTEM DISARMING WITH ALARM MEMORY:
If an alarm event occurs while the alarm is armed, disarming will be confirmed by 1 Bop and 1 flash of the turn
indicators followed by one of more flashes of the turn indicators and Beeps according to the last alarm event:
 2 Beeps and 2 flashes of the turn indicators => ignition attempt
 3 Beeps and 2 flashes of the turn indicators => seat/topcase input
 4 Beeps and 2 flashes of the turn indicators => wire tampering
 5 Beeps and 2 flashes of the turn indicators => tilt sensor
N.B.: If the acoustic signals have been disabled, only the turn indicators will flash as indicated above.
BASIC FUNCTIONS
ALARM DURATION
25 sec.
25 sec.
25 sec.
25 sec.
ALARM CYCLES
Unlimited
7 alarm cycles
Unlimited
7 alarm cycles
9/39