Gemini 1D002554 Mode D'emploi page 12

2) PIN code customization:
When you change the factory preset PIN code you must remember the new code in case you need to emergency
override the alarm and keep it confidential to avoid unauthorized use of the vehicle.
a) Press remote control BUTTON 1 (1 confirmation Beep), followed by BUTTON 2 (1 confirmation Bop), the LED
will turn OFF. Entry in customization mode is confirmed by 1 Beep ‐ Bop.
b) Turn ignition key OFF;
c) After 4 sec., the LED will flash 9 times in sequence.
d) Count the number of flashes and cycle ignition key ON and OFF when the number of flashes equals that of
the new PIN code 1st digit;
e) After another 4 sec., there will be another sequence of LED flashes. When the number of flashes equals that
of the 2nd digit, cycle ingnition key ON and OFF to enter the new PIN code 2nd digit;
f) Repeat the above steps to enter the last 2 digits.
g) The system automatically exits the procedure with a "Bop" ‐ "Bop" ‐ "Beep" confirmation tone.
3) Tilt sensor adjustment:
The alarm system has a built‐in triaxial tilt sensor with 5 levels of sensitivity adjustment. The sensor is factory preset
to be at minimum sensitivity.
To change the sensitivity level proceed as follows:
a) Press remote control BUTTON 2 (1 confirmation Bop), press BUTTON 2 again (1 confirmation Bop), the LED
will power OFF. Two Bops will confirm the system is in adjustment mode.
N.B.: The sensor is at the lowest level of sensitivity.
b) Press BUTTON 2 to increase sensitivity by one (press 4 times to set at maximum level). A LED flash and a
Beep will confirm each change of setting.
c) When the sensor is adjusted, turn ignition key OFF. A LED flash and a "Bop" ‐ "Bop" ‐ "Beep" will confirm the
end of the procedure.
d) If adjusted at the highest level (4 button presses), the system automatically exits the procedure. Exit is
confirmed by 1 LED flash and 1 "Bop" ‐ "Bop" ‐ "Beep". Turn ignition key OFF.
N.B.: Every time you enter the programming procedure, sensitivity is restored to the factory default
setting (lowest sensitivity level).
4) Learning new remote controls:
Alarm memory will store up to 8 remote controls. Saving an extra device will automatically delete the first one.
ATTENTION: Every time you enter in "learn mode", all the previously learned remote controls, except the one
used to enter in programming mode, will be deleted. The LED will power ON to confirm the system is in "learn
mode".
Make sure the system is disarmed before activating the procedure.
a) Press remote control BUTTON 2 (1 confirmation Bop), press BUTTON 1 (1 confirmation Beep). A Bop‐Beep
will confirm entering the procedure.
b) Press BUTTON 1 on the remote control to be learned: if learning is successful, a Beep will sound and the LED
will turn OFF for 1 sec.;
c) To learn other remote controls, repeat step b);
d) Turn ignition key OFF: the LED will turn OFF to confirm the system is no longer in programming mode.
12/39