Gemini 1D002554 Mode D'emploi page 13

14. LEARNING NEW REMOTE CONTROLS WITHOUT AN OPERATIVE REMOTE CONTROL
a) If the system is armed, use the PIN code to disarm it.
b) Lift the seat or the topcase (if protected by a contact switch) otherwise connect the GREEN/BROWN wire
(seat/topcase input) to a positive feed (+12Vdc).
c) Turn ignition key ON.
d) The LED will power ON for 1 sec..
e) When the LED turns OFF, within 5 sec., simultaneously press, twice in a row, BUTTONS 1 and 2 on the
remote control to be learned.
f) Successful learning will be confirmed by 1 flash of the LED and 1 Beep.
g) Close the seat or topcase or disconnect the GREEN/BROWN wire from the positive feed.
15. ALARM SYSTEM WIRING PINOUT
16. TECHNICAL SPECIFICATIONS
Nominale supply voltage:
Current consumption in Standby mode:
Current consumption in Sleep mode:
Seat release:
Immobilizer relay capacity:
Siren sound level:
Turn indicator output capacity:
Radio frequency:
PIN
1 Positive feed +12Vdc
2 Ignition input (+15/54)
3 N.C.
4 LED positive output
5 LH indicator output
6 RH indicator output
7 Supply ground
8 Seat/topcase positive input
9 Immobilizer relay NC contact
10 Immobilizer relay CC contact
11 Immobilizer relay NA contact
12 Output for seat/topcase release actuator
12Vdc
<3mA
<1mA
max. 6A - Positive pulse
max. 8A - Contact capacity
max. 108 - 110dB @ 1m
max. 6A
433.92MHz
Description
13/39